Dell PowerEdge T360 - Expansion Card Riser Specifications; Memory Specifications; Storage Controller Specifications

Expansion card riser specifications
The PowerEdge T360 system supports up to four PCIe slots (three Gen4 and one Gen5) on the system board.
Table 11. Expansion card slots supported on the system board
PCIe slot Expansion card riser
Processor
connection
Height Length Slot width
Slot 1
(Gen4)
N/A Processor 1 Full Height Half Length x4
Slot 2
(Gen5)
N/A Processor 1 Full Height Half Length x16
Slot 3
(Gen4)
N/A
Platform Controller
Hub
Full Height Half Length x1
Slot 4
(Gen4)
N/A
Platform Controller
Hub
Full Height Half Length x4
Memory specifications
The PowerEdge T360 system supports DDR5 UDIMM ECC memory in the following memory specifications for optimized
operation.
Table 12.
Memory specifications
DIMM type DIMM rank DIMM capacity
Single processor
Minimum system capacity
Maximum system
capacity
DDR5 ECC UDIMM
Single rank 16 GB 16 GB 64 GB
Dual rank 32 GB 32 GB 128 GB
Table 13. Memory module sockets
Memory module sockets Speed
4, 288-pin Up to 4400 MT/s
NOTE: Memory DIMM slots are not hot pluggable.
NOTE: The processor may reduce the performance of the rated DIMM speed. For more information, refer T360 Technical
Guide at poweredge manuals.
Storage controller specifications
The PowerEdge T360 system supports the following controller cards:
Table 14.
Storage controller cards 
Supported storage controller cards
Internal controllers
● PERC H355 Adapter
● PERC H755 Adapter
● HBA355i Adapter
External controllers
● HBA355e Adapter
Technical specifications 23