Dell PowerEdge XR5610 - Expansion Cards and Expansion Card Risers

Figure 93. Set the anti-tilt wires to the locked position and tightening the nuts
Next steps
1. Replace the processor air shroud.
2. Follow the procedure listed in After working inside your system.
Expansion cards and expansion card risers
NOTE:
When an expansion card is not supported or missing, the iDRAC and Lifecycle Controller logs an event. This does
not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see Troubleshooting
expansion cards section in the PowerEdge Servers Troubleshooting Guide at www.dell.com/poweredgemanuals.
122 Installing and removing system components