Installing the bezel filter for Rear Accessed configuration
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Remove the front bezel.
NOTE: The procedure to install the bezel filter is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Place the new filter in the bezel cavity under the bezel grill. Ensure that the filter is properly placed in the hooks of the bezel
cavity.
2. Align the bezel grill with bezel and press the grill on the securing brackets location to secure it in place.
Figure 34. Installing the front bezel filter
Next steps
Install the front bezel.
System cover
Removing the system cover
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
1. Using a 1/4-inch flat head or Phillips 2 screwdriver, rotate the lock counter clockwise to the unlock position.
2. Lift the release latch fully until the system cover slides back.
NOTE: The release latch must be fully lifted for the system cover to be released.
3. Lift the cover from the system.
78
Installing and removing system components
To Next Page
Loading...
