Steps
1. Loosen the three screws to remove the left ear for the Front Accessed configuration.
2. Disconnect the power button control panel cable from the system board connector and remove the cable from cable clip.
NOTE: Observe the routing of the cable as you remove it from the system.
3. Using the Phillips 2 screwdriver, remove the screws that secure the left rack ear.
4. Using the Torx 8 screwdriver, remove the screws that secure the power button control panel assembly.
5. Hold the power button control panel assembly and remove the control panel along with the cable from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 140. Removing the left ear for the Front Accessed configuration
Figure 141. Removing the power button control panel for Front Accessed configuration
Next steps
Replace the power button control panel for Front Accessed configuration.
Installing the power button control panel for Front Accessed
configuration
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Installing and removing system components
163
To Next Page
Loading...
