Table 11. Chassis dimensions(continued)
Drives Xa Xb Y Za without bezel Za with
bezel
Zb Zc
Front
Accessed
configuration
482.6 mm
(19 inches)
434.0 mm
(17 inches)
42.8 mm
(1.68 inches)
47.75 mm (1.88
inches) (left ear)
31.35 mm (1.23
inches) (right ear)
148 mm (5.82
inches) Back
of rack ear to
most outer
surface of
bezel
409 mm (16.10
inches) Back
of ear to
chassis face
417 mm (16.41
inches) Back
of ear to MIL
drive bracket
edge
NOTE: Without the front bezel, Rear Accessed configuration support racks with 80 mm spacing from rack post to inside
surface of rack door. With the front bezel installed, the Rear Accessed configuration system support racks with 100 mm
spacing from rack post to inside surface of the rack door.
System weight
Table 12. PowerEdge XR5610 system weight
System configuration Maximum weight (with all drives/SSDs/rails/bezel)
Rear Accessed configuration 11.27 kg (24.8 pounds)
Front Accessed configuration 11.37 kg (25.1 pounds)
Processor specifications
Table 13. PowerEdge XR5610 processor specifications
Supported processor Number of processor supported
4
th
Generation Intel Xeon Scalable and Edge-Enhanced
processor and Edge-Enhanced CPUs with up to 32 cores
One
PSU specifications
The PowerEdge XR5610 system supports up to two AC or DC power supply units (PSUs).
Table 14. PSU specifications
PSU Class Heat
dissipation
(maximum)
Frequency Voltage DC DC Current
High line
240 V DC
Low line
1800 W
Mixed Mode
Titanium 5406 BTU/
hr
50/60 Hz 200-240 V
AC,
autoranging
1800 W 1050 W NA 10 A
Titanium 5406 BTU/
hr
NA 240 V DC NA NA 1400 W 8.2 A
1400 W
Mixed Mode
Platinum 5406 BTU/
hr
50/60 Hz 100–240 V
AC,
autoranging
1400 W 1050 W NA 12 A-8 A
Platinum 5406 BTU/
hr
NA 240 V DC NA NA 1400 W 6.6 A
1100 W
Mixed Mode
Titanium 4299 BTU/
hr
50/60 Hz 100–240 V
AC,
autoranging
1100 W 1050 W NA 12 A-6.3 A
30 Technical specifications
To Next Page
Loading...
