Bezel LED
The bezel status LED is located on the front panel of the Rear and Front Accessed configuration system.
Figure 150. Bezel LED
1. Bezel LED
Table 107. Bezel LED description
Power button LED indicator code Condition
LED off System is off, no errors, and system ID mode is not active.
Solid blue System is on, no errors, and system ID mode is not active.
Blinking amber (2 seconds on, 1 second off) There are active errors present. This mode supersedes all states listed above
and can be active when the system is on or off.
Blinking blue (0.5 Hz = 1 second on, 1 second
off)
System ID mode is active. This mode supersedes all states listed above and
can be active when the system is on or off.
Status LED indicators
NOTE: The indicators display solid amber if any error occurs.
Figure 151. Status LED indicators
Table 108. Status LED indicators and descriptions
Icon Description Condition Corrective action
Drive indicator
The indicator turns solid amber if
there is a drive error.
● Check the System Event Log to determine if the
drive has an error.
● Run the appropriate Online Diagnostics test.
Restart the system and run embedded
diagnostics (ePSA).
● If the drives are configured in a RAID array,
restart the system, and enter the host adapter
configuration utility program.
Temperature
indicator
The indicator turns solid amber if
the system experiences a thermal
error (for example, the ambient
temperature is out of range or
there is a fan failure).
Ensure that none of the following conditions exist:
● A cooling fan has been removed or has failed.
● System cover, air shrouds, or back filler bracket
has been removed.
● Ambient temperature is too high.
● External airflow is obstructed.
If the problem persists, see the Getting help section.
System diagnostics and indicator codes 171
To Next Page
Loading...
