about the Part replacement configuration, see the Dell Lifecycle Controller User's Guide available at https://www.dell.com/
idracmanuals
M.2 SSD module
Removing the BOSS N1 card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
NOTE: The procedure to remove the BOSS N1 card is the same for Rear Accessed and Front Accessed configurations.
Steps
Holding the blue tag, pull the BOSS N1 card away from the system board connector.
Figure 106. Removing the BOSS N1 card
Next steps
Replace the BOSS N1 card.
Installing the BOSS N1 card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
NOTE: The procedure to install the BOSS N1 card is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Align and insert the BOSS N1 card connector with the connectors on the system board.
2. Press the BOSS N1 card firmly until it is fully seated.
Installing and removing system components
133
To Next Page
Loading...
