Dell PowerEdge XR5610 - Drives Specifications; Ports and Connectors Specifications; USB Ports Specifications; Display Port Specifications

Table 19. PowerEdge XR5610 system storage controller specifications(continued)
Supported storage controller cards
● HBA355i
NOTE: The XR5610 backplane support up to SAS3 speed only for SAS drives.
Drives specifications
ThePowerEdge XR5610 system supports 4 x 2.5-inch SAS, SATA, or NVMe SSD drives.
NOTE: For more information about how to hot swap NVMe PCIe SSD U.2 device, see the Dell Express Flash NVMe
PCIe SSD User's Guide at https://www.dell.com/support > Browse all products > Infrastructure > Data Center
Infrastructure > Storage Adapters & Controllers > Dell PowerEdge Express Flash NVMe PCIe SSD > Select This
Product > Documentation > Manuals and Documents.
NOTE: Spinning hard drives are not supported in the XR5610.
Ports and connectors specifications
USB ports specifications
Table 20. PowerEdge XR5610 system USB ports specifications for Rear Accessed configuration
Front Rear
USB port type No. of ports USB port type No. of ports
USB 2.0-compliant port One USB 3.0-compliant port One
iDRAC Direct port (Micro-AB
USB 2.0-compliant port)
One
Table 21. PowerEdge XR5610 system USB ports specifications for Front Accessed configuration
Front Rear
USB port type No. of ports USB port type No. of ports
USB 3.0-compliant port One None
iDRAC Direct port (Micro-AB
USB 2.0-compliant port)
One
NOTE: The micro USB 2.0 compliant port can only be used as an iDRAC Direct or a management port.
Display port specifications
The PowerEdge XR5610 system supports 1 x Mini-DisplayPort on the rear of the Rear Accessed configuration and on the front
of the Front Accessed configuration.
GPU specifications
The PowerEdge XR5610 system supports up to two 75 W/150 W (single-width, low-profile, and half-length) GPUs.
34
Technical specifications