Figure 45. Removing the intrusion switch module
Next steps
Before working inside your system.
Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
NOTE:
The procedure to install the intrusion switch module is the same for Rear Accessed and Front Accessed
configurations.
NOTE: Ensure that you note the routing of all the cables as you remove them from the system board. Route the intrusion
switch cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align and insert the intrusion switch module until it is firmly seated in the slot on the system.
2. Using the Phillips 1 screwdriver, tighten the screw securing the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the power interposer board (PIB).
Installing and removing system components
87
To Next Page
Loading...
