iDRAC9 port specifications
The PowerEdge XR5610 system supports 1 x RJ45 with port status LEDs for iDRAC remote management (dedicated port only)
on rear of the Rear Accessed configuration and on the front of the Front Accessed configurations.
Serial connector specifications
The PowerEdge XR5610 system supports one Micro USB Type B serial connector located on the rear of the Rear Accessed
configuration and on the front of the Front Accessed configuration.
RJ45 dry contact
The PowerEdge XR5610 system supports 1 x RJ45 for dry contact on rear of the Rear Accessed configuration and on the front
of the Front Accessed configuration.
To enhance usage in IoT space, the XR5610 comes with dry input sensor. Each input are configurable and manageable in the
iDRAC interface. These are interruptible inputs to iDRAC. Dry means no energy is supplied to the contacts.
Figure 27. iDRAC interface for Dry Input sensors
NOTE: The RJ45 for dry contact does not support IP function.
The default state of the dry inputs are off/disabled. User will have 7 (one for each dry input) enable/disable (default) control
that must be enabled before logging will occur.
Technical specifications
35
To Next Page
Loading...
