Dell PowerEdge XR5610 - Removing the Power Button Control Panel for Front Accessed Configuration

Figure 138. Installing the power button control panel for Rear Accessed configuration
5. Using the Phillips 2 screwdriver, tighten the screws that secure the right ear handle to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 139. Installing the right ear handle for Rear Accessed configuration
Next steps
1. Install the expansion card riser 1.
2. Install the air shrouds.
3. Follow the procedure listed in the After working inside your system.
Removing the power button control panel for Front Accessed
configuration
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the Riser 1.
162
Installing and removing system components