Table 103. Configuration 1: R3(continued)
Card type Slot Priority Maximum number of cards
Broadcom (NIC: 10G) (FH) 1,2 2
Broadcom (NIC: 1G) V2 1,2 2
Intel (NIC: 25G) (FH) 2P,S28 1,2 2
Intel (NIC: 10G) (FH) 4P,BT 1,2 2
Intel (NIC: 1G) V3 1,2 2
Intel (NIC: 1G) (FH) 2P,BT 1,2 2
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
NOTE: The procedure to remove the expansion card risers is the same for Rear Accessed and Front Accessed
configurations.
Steps
For riser 3, first disconnect the cables from the system board. Using the Phillips 2 screwdriver, loosen the blue thumbscrew.
Holding the blue touch points, lift the expansion card riser from the riser connector on the system board.
Figure 97. Removing the expansion card riser 3
Next steps
Replace the expansion card riser.
Installing and removing system components
127
To Next Page
Loading...
