● Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).
NOTE: For information about DC PSU cabling instructions, go to https://www.dell.com/poweredgemanuals > XR Servers
> PowerEdge XR5610 > Select This Product > Documentation > Manuals and Documents > Cabling instructions for –
48 – 60 V DC power supply.
Front bezel
Removing the front bezel
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
Press the two side buttons to release the bezel.
Figure 29. Removing the front bezel for Rear Accessed configuration
74
Installing and removing system components
To Next Page
Loading...
