Figure 119. Installing the power interposer board
3. Reconnect all the required cables.
Next steps
1. Install the PSU.
2. Install the PCI air shroud.
3. Follow the procedure listed in After working inside your system.
Optional OCP card
Removing the OCP riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
3. Remove the system cover.
Steps
1. Using a Phillips 2 screwdriver, loosen the captive screw and the two screws on the chassis.
2. Disconnect the signal cable and power cable from the system board connectors.
3. Lift the OCP riser from the OCP riser slot.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
144 Installing and removing system components
To Next Page
Loading...
