Installing a power supply unit
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. For systems that support redundant Power Supply Units (PSUs), ensure that both the PSUs are of the same type and have
the same maximum output power.
NOTE: The maximum output power (shown in watts) is listed on the PSU label.
3. Remove the PSU blank.
NOTE: The PowerEdge XR5610 has two types of Power Supply Units (PSUs). The PSUs with black straps are designed for
Rear Accessed configuration while the PSUs with blue straps are designed for Front Accessed configuration.
Steps
Slide the PSU into the PSU bay until the release latch snaps into place.
Figure 116. Installing a power supply unit for Rear Accessed configuration
Figure 117. Installing a power supply unit for Front Accessed configuration
Installing and removing system components
141
To Next Page
Loading...
