Figure 104. Installing a low-profile expansion card into Riser 3
Figure 105. Installing a full-height expansion card into Riser 3 (Intel Ethernet 25G 4P E810-XXV-stg Adapter)
NOTE:
Before installing the Intel(R) Ethernet 25G 4P E810-XXV-stg Adapter, ensure the NCSI cable is properly routed
as shown in the image to avoid damage.
Next steps
1. Follow the procedure listed in After working inside your system.
2. Install any device drivers required for the card as described in the documentation for the card.
NOTE:
While replacing a faulty storage controller or NIC card or GPU with the same type of card, after you power on the
system; the new card automatically updates to the same firmware and configuration of the faulty one. For more information
132 Installing and removing system components
To Next Page
Loading...
