Figure 101. Removing a full-height expansion card from Riser 3
3. If the expansion card is not going to be replaced, install a filler bracket and close the card retention latch.
NOTE:
You must install a filler bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
Figure 102. Installing filler bracket in Riser 3
Next steps
If applicable, install an expansion card into the expansion card riser.
130
Installing and removing system components
To Next Page
Loading...
