230 Adding and Replacing Parts
Replacing the Video Card/Thermal-Cooling Assembly
1
Carefully align the video card/thermal-cooling assembly over the connector
on the system board and press down.
NOTE: The video card/thermal-cooling assembly is labeled "PUSH HERE."
2
Tighten the four captive screws on the video card/thermal-cooling
assembly.
System Fan(s)
Removing the System Fan(s)
CAUTION: Before you begin the following procedure, follow the safety
instructions in the
Product Information Guide
.
1 captive screws 2 video card/thermal-cooling assembly
3 system board connector
1
3
2
book.book Page 230 Tuesday, August 28, 2007 10:20 AM
To Next Page
Loading...
