Dell S3845cdn - Entering Specific Symbols

254 | Faxing
3 To specify multiple recipients, repeat steps 1 and 2.
NOTE:
• If you have entered an incorrect value, tap the number, select Remove from the popup menu,
and delete the incorrect value.
To modify the incorrect value, select Edit from the popup menu.
Entering Specific Symbols
When specifying a recipient, you can use the following features to enter specific symbols
on the touch screen.
Starting the Fax Job
1 Select Send.
NOTE:
• If the document has been loaded in the document feeder, do not hold down the document
while it is being conveyed.
• If you have more documents to fax, select Add Page on the touch screen while the current
document is being scanned. This allows you to send the documents as one set of data.
If you finished scanning, skip steps 2 to 4.
Feature Button Function Input method
Enter pause , (Dial
Pause)
Used to enter a pause.
One pause is 3 seconds.
You can enter pauses of 6 seconds,
9 seconds, etc. with additional
button presses.
1. Select to switch the
onscreen keypad.
2. Select , (Dial Pause).
(Example)
0,123 ...
0,,123 ...
Detect the
tone
= (Wait) Used to perform the tone detection
within the specified time length.
1. Select to switch the
onscreen keypad.
2. Select = (Wait).
Mask the
entered value
/ (Mask) Used to mask the entered value by
displaying as "*".
1. Select to switch the
onscreen keypad.
2. Select / (Mask) to start masking.
3. Enter the value to be replaced
with "*" for showing on the screen.
4. Select / (Mask) to finish
masking.
(Input Example)
a/1234/5678/90ab
(Display Example)
a/****/5678/****
Switch to the
PB signal
: (Pulse →
Tone)
Used to switch the tone signal from
DP to PB.
1. Select to switch the
onscreen keypad.
2. Select : (Pulse → Tone).
Transmit using
a password
S (Password) When a password has been set,
transmission will start only if the
password matches the ID number
on the remote terminal.
1. Select to switch the
onscreen keypad.
2. Select S (Password).
(Example)
0312345678S12345678