Dell S3845cdn - Page 263

Faxing | 263
4 When the call is finished, place the receiver back in the cradle.
NOTE:
• Be sure that the receiver is placed properly in the cradle. Otherwise, the line remains "busy".
On-hook Dialing
The following describes how to place a call with on-hook dialing. Adjust the line monitor
volume so that you can hear the sound clearly.
NOTE:
• See "Sounds".
1 Enable Manual Send on the Fax app.
2 Select Dial.
3 Specify the call destination.
NOTE:
• To disconnect the call, close the Dial screen.
• If your telephone line is set to touch-tone, “:” (Tone) does not appear.
• If you want to send tones (or to use the touch-tone services) while using a pulse line, select “:”
(Tone).
• Some touch-tone services may not be available even if you set your telephone to send tones.
4 When the call is connected, lift the receiver and start speaking.
5 After the call is finished, place the receiver back in the cradle.
NOTE:
• Make sure that the receiver is placed properly in the cradle. Otherwise, the line remains "busy".