Delta Electronics ASDA-B2 series User Manual

ASDA-B2 Chapter 7 Servo Parameters
Revision September 2013 7-87
Unit: N/A
Range: Read only
Data Size: 16-bit
Display
Format:
Hexadecimal
Settings:
This parameter is used to check if MODE, UP, DOWN, SHIFT, and SET keys on the
drive keypad being pressed or not. It is used to examine if these five keys work
normally via communication during production.
P4-09★
MOT Output Status (Read-only)
Address: 0412H
0413H
Operation
Interface:
Keypad / Software Communication
Related Section:
Section 4.4.5
Default: N/A
Control
Mode:
ALL
Unit: N/A
Range: 0 ~ 0x3F
Data Size: 16-bit
Display
Format:
Hexadecimal
Settings:
There is no difference when reading DO output signal via the drive keypad or the
communication.
P4-10■
CEN Adjustment Function
Address: 0414H
0415H
Operation
Interface:
Keypad / Software Communication
Related Section: N/A
Default: 0
Control
Mode:
ALL
Unit: N/A
Range: 0 ~ 6
Data Size: 16-bit
Display
Format:
Decimal
Settings:
0: Reserved
1: Execute analog speed input drift adjustment
2: Execute analog torque input drift adjustment
3: Execute current detector (V phase) drift adjustment
4: Execute current detector (W phase) drift adjustment
5: Execute drift adjustment of the above 1~4
6: Execute IGBT NTC calibration
Please note:
VARITEL INGENIERIA ELECTRONICA S.A.
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.

Delta Electronics ASDA-B2 series Specifications

General

Brand	Delta Electronics
Model	ASDA-B2 series
Category	Servo Drives
Language	English