Seven
™
System User’s Guide | 75
Remove your Sensor Pod by gently peeling up the adhesive patch from you skin (this will
pull out the Sensor Probe). Remove the Transmitter from the Sensor Pod and store it for
your next glucose monitoring session (see Section 5.2).
To start a new Seven System continuous glucose monitoring session, insert a new Sensor,
notify the Receiver and then calibrate at the end of the Start-Up Period (see Section 2).
NOTE
Remember to save your Transmitter after each Sensor removal. e same Transmitter
is used for each Seven session until you have reached the end of the Transmitter
battery life.
To Next Page
Loading...
