Digi Connect EZ Mini - Page 115

Serial port Configure Remote Access mode
Digi Connect EZ Mini User Guide
115
(config)>serial port1 framing strip_pattern true
(config)
17. (Optional) Configure service settings:
a. Configure SSH settings:
i. Enable SSH:
(config)>serial port1 service ssh enable true
(config)>
ii. Set the port to be used for ssh communications:
(config)>serial port1 service ssh port int
(config)>
where int is any integer between 1 and 65535. The default is 3001.
iii. Enable TCPkeep-alive messages:
(config)>serial port1 service ssh keepalive true
(config)>
iv. Enable TCP nodelay messages:
(config)>serial port1 service ssh nodelay true
(config)>
v. (Optional) Configure access control:
n To limit access to specified IPv4 addresses and networks:
(config)> add serial port1 service ssh acl address end value
(config)>
Where value can be:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 192.168.1.0/24.
l any: No limit to IPv4 addresses that can access the service-type.
Repeat this step to list additional IP addresses or networks.
n To limit access to specified IPv6 addresses and networks:
(config)> add serial port1 service ssh acl address6 end value
(config)>
Where value can be:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 2001:db8::/48.
l any: No limit to IPv6 addresses that can access the service-type.
Repeat this step to list additional IP addresses or networks.
n To limit access to hosts connected through a specified interface on the
Connect EZ device: