Serial port Configure Remote Access mode
Digi Connect EZ Mini User Guide
114
When using SSH, this should be prefixed with the user name and followed by @, for
example:
(config)>serial port1 autoconnect destination admin@192.168.1.1
(config)>
e. Set the TCP port of the destination server:
(config)>serial port1 autoconnect port int
(config)>
where int is any integer between 1 and 65535.
f. To enable TCP keepalive:
(config)>serial port1 autoconnect keepalive true
(config)>
g. To enable TCPnodelay:
(config)>serial port1 autoconnect nodely true
(config)>
h. Set the text to be transmitted to the remote server when the socket connects:
(config)>serial port1 socketid string
(config)>
16. (Optional) Configure data framing:
a. Enable data framing:
(config)>serial port1 framing enable true
(config)
b. Set the maximum size of the packet:
(config)>serial port1 framing max_count int
(config)
The default is 1024.
c. Set the length of time the device should wait before sending the packet:
(config)>serial port1 framing idle_time value
(config)
where value is in milliseconds (ms) or seconds (s). The maximum value is 60s.
d. Set the end pattern. The packet is sent when this pattern is received from the serial port:
(config)>serial port1 framing end_pattern backslash-escaped-string
(config)
e. Set the strip end pattern if you want to remove the end pattern from the packet before it
is sent:
To Next Page
Loading...
Need help?
General