Digi Connect EZ Mini User Manual

Serial port Configure PPP dial-in mode
Digi Connect EZ Mini User Guide
128
9. Set the local IP address assigned to this interface:
(config)> serial port1 ppp_dialin local_address IPv4_address
(config)>
10. Set the IP address assigned to the remote peer:
(config)> serial port1 ppp_dialin remote_address IPv4_address
(config)>
11. The default route is added for the PPP interface is disabled by default. To enable:
(config)> serial port1 ppp_dialin default_route true
config)>
12. Set the authentication method used to authenticate the remote peer:
(config)> serial port1 ppp_dialin auth value
(config)>
where value is one of:
n none: No authentication is required.
n auto: Attempt to authenticate using CHAP first, and then PAP.
n chap: Use Challenge Handshake Authentication Protocol (CHAP) to authenticate.
n pap: Use Password Authentication Protocol (PAP) to authenticate.
The default is none.
If auto, chap, or pap are set, set the username and password used to authenticate the remote
peer:
(config)> serial port1 ppp_dialin username username
(config)> serial port1 ppp_dialin password password
(config)>
13. Set the priority of routes associated with this interface. If there are multiple active routes that
match a destination, then the route with the lowest metric will be used.
(config)> serial port1 ppp_dialin metric int
(config)>
The default is 10.
14. Set the firewall zone for this interface. This can be used by packet filtering rules and access
control lists to restrict network traffic on this interface.
a. Use the ? to determine available zones:
(config)> serial port1 ppp_dialin zone ?
Zone: The firewall zone assigned to this interface. This can be used by
packet
filtering rules and access control lists to restrict network traffic on
this

Digi Connect EZ Mini Specifications

General

Brand	Digi
Model	Connect EZ Mini
Category	Server
Language	English