Serial port Configure PPP dial-in mode
Digi Connect EZ Mini User Guide
127
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect EZ local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. The serial port is enabled by default. To disable:
(config)> serial port1 enable false
(config)>
4. Set the mode:
(config)> serial port1 mode ppp_dialin
(config)>
5. (Optional) Set a label that will be used when referring to this port.
(config)> serial port1 label label
(config)>
6. Set the baud rate used by the device to which you want to connect:
(config)> serial port1 baudrate rate
(config)>
7. Set the type of flow control used by the device to which you want to connect:
(config)> serial port1 flow value
(config)>
where value is one of:
n none
n rts/cts
n xon/xoff
8. Set the amount of time that the active session can be idle before the session is disconnected:
(config)> serial port1 idle_timeout value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set idle_timeout to ten minutes, enter either 10m or 600s:
(config)> serial port1 idle_timeout 600s
(config)>
To Next Page
Loading...
Need help?
General