User authentication Terminal Access Controller Access-Control System Plus (TACACS+)
Digi Connect EZ Mini User Guide
535
d. (Optional) Repeat the above steps to add additional TACACS+ servers.
9. Add TACACS+ to the authentication methods. Authentication methods are attempted in the
order they are listed until the first successful authentication result is returned. This example
will add TACACS+ to the end of the list. See User authentication methods for information about
adding methods to the beginning or middle of the list.
(config)> add auth method end tacacs+
(config)>
10. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
To Next Page
Loading...
Need help?
General