System administration Erase device configuration and reset to factory defaults
Digi Connect EZ Mini User Guide
617
n Erases all automatically generated certificates and keys.
n With firmware release 22.2.9.x and newer, erases the client-side certificate used for
communication with Digi Remote Manager.
If you are using Digi Remote Manager with firmware release 22.2.9.x and newer, by default the
device uses a client-side certificate for communication with Remote Manager. If the client-side
certificate is erased, you must use the Remote Manager interface to reset the certificate.
n If your device uses a custom factory default, the custom factory default will be removed and
the device will reboot using standard factory default settings.
You can also reset the device to the default configuration without removing scripts, keys, and logfiles
by using the revert command.
Web
1. Log into the Connect EZ WebUI as a user with Admin access.
2. On the main menu, click System. Under Configuration, click Configuration Maintenance.
The Configuration Maintenance windows is displayed.
3. In the Erase configuration section, click ERASE.
4. Click CONFIRM.
5. After resetting the device:
a. Connect to the Connect EZ by using the serial port or by using an Ethernet cable to
connect the Connect EZ ETH2 port to your PC.
b. Log into the Connect EZ:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
To Next Page
Loading...
Need help?
General