Diagnostics Analyze network traffic
Digi Connect EZ Mini User Guide
704
4. For Add Capture settings, type a name for the capture filter and click .
The new capture filter configuration is displayed.
5. (Optional) Add a filter type:
a. Click to expand Filter.
You can select from preconfigured filters to determine which types of packets to capture
or ignore, or you can create your own Berkeley packet filter expression.
b. To create a filter that either captures or ignores packets from a particular IP address or
network:
i. Click to expand Filter IP addresses or networks.
ii. Click to add an IP address/network.
iii. For IP address or network, type the IPv4 or IPv6 address (and optional netmask).
iv. For Source or destination IP address, select whether the filter should apply to
packets when the IP address/network is the source, the destination, or both.
v. Click Ignore this IP address or network if the filter should ignore packets from this
IP address/network. By default, is option is disabled, which means that the filter will
capture packets from this IP address/network.
vi. Click to add additional IP address/network filters.
To Next Page
Loading...
Need help?
General