Interfaces Wide Area Networks (WANs)
Digi Connect EZ Mini User Guide
72
If Custom test is selected, complete the following:
l The Commands to run to test.
n TCP connection test: Tests that the interface can reach a destination port on the
configured host.
If TCP connection test is selected, complete the following:
l TCP connect host: The hostname or IP address of the host to create a
TCPconnection to.
l TCP connect port: The TCP port to create a TCPconnection to.
n Test another interface's status: Tests the status of another interface.
If Test another interface's status is selected, complete the following:
l Test interface: The interface to test.
l IP version: The type of IP connection, one of:
o
Any: Either the IPv4 or IPv6 connection must be up.
o
Both: Both the IPv4 or IPv6 connection must be up.
o
IPv4: The IPv4 connection must be up.
o
IPv6: The IPv6 connection must be up.
l Expected status: The status required for the test to past.
o
Up: The test will pass only if the referenced interface is up and passing its own
SureLink tests (if applicable).
o
Down: The test will pass only if the referenced interface is down or failing its own
SureLink tests (if applicable).
13. Configure the device to reboot when the test fails:
a. Click to expand Recovery actions.
b. Click .
New recovery actions are enabled by default. To disable, click to toggle off Enable.
c. Type a Label for the recovery action.
d. For Recovery type, select Reboot device.
n Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
n Override wait interval before performing the next recovery action: The time to
wait before the next test is run. If set to the default value of 0s, the Test interval is
used.
14. (Optional) Configure advanced SureLink parameters:
a. Click to expand Advanced settings.
b. For Delayed Start, type the amount of time to wait while the device is starting before
SureLink testing begins. This setting is bypassed when the interface is determined to be
up.(missing or bad snippet)
The default is 300 seconds.
To Next Page
Loading...
Need help?
General