AT commands I/O sampling commands
XBee®-PRO 900HP/XSC RF Modules
103
M1 (PWM1 Duty Cycle)
The duty cycle of the PWM1 line (pin 7).
Use the P1 command to configure the line as a PWM output.
Parameter range
0 - 0x3FF
Default
0
LT (Associate LED Blink Time)
Set or read the Associate LED blink time. If you use the D5 command to enable the Associate LED
functionality (DIO5/Associate pin), this value determines the on and off blink times for the LED.
If LT = 0, the device uses the default blink rate: 500 ms for a sleep coordinator, 250ms for all other
nodes.
For all other LT values, the firmware measures LT in 10 ms increments.
Parameter range
0x14 - 0xFF (x 10 ms)
Default
0
RP (RSSI PWM Timer)
The PWM timer expiration in 0.1 seconds. RP sets the duration of pulse width modulation (PWM) signal
output on the RSSI pin.
When RP = 0xFF, the output is always on.
Parameter range
0 - 0xFF (x 100 ms)
Default
0x28 (four seconds)
I/O sampling commands
The following AT commands configure I/O sampling parameters.
AV (Analog Voltage Reference)
The analog voltage reference used for A/D sampling.
Parameter range
0 - 2
0, 1
To Next Page
Loading...
Need help?
General
