AT commands Security commands
XBee®-PRO 900HP/XSC RF Modules
91
Security commands
The following AT commands are security commands.
EE (Security Enable)
Enables or disables 128-bit Advanced Encryption Standard (AES) encryption.
Set this command parameter the same on all devices in a network.
Parameter range
0 - 1
Parameter Description
0 Encryption Disabled
1 Encryption Enabled
Default
0
KY (AES Encryption Key)
Sets the 16-byte network security key value that the device uses for encryption and decryption.
This command is write-only. If you attempt to read KY, the device returns an OK status.
Set this command parameter the same on all devices in a network.
The value passes in as hex characters when you set it from AT command mode, and as binary bytes
when you set it in APImode.
Parameter range
128-bit value
Default
N/A
Serial interfacing commands
The following AT commands are serial interfacing commands.
BD (Baud Rate)
Values from 0 - 8 select preset standard rates.
Values at 0x39 and above select the actual baud rate if the host supports it.
Parameter range
Standard baud rates: 0x0 - 0x8
Non-standard baud rates: 0x100 to 0x6ACFC0
To Next Page
Loading...
Need help?
General
