AT commands I/O sampling commands
XBee®-PRO 900HP/XSC RF Modules
104
Parameter Description
0 1.25 V reference
1 2.5 V reference
Default
0
IC (DIO Change Detection)
Set or read the digital I/O pins to monitor for changes in the I/O state.
IC works with the individual pin configuration commands (D0 - D9, P0 - P2) . If you enable a pin as a
digital I/O, you can use the IC command to force an immediate I/O sample transmission when the DIO
state changes. IC is a bitmask that you can use to enable or disable edge detection on individual
channels.
Set unused bits to 0.
Bit I/O line
0 DIO0
1 DIO1
2 DIO2
3 DIO3
4 DIO4
5 DIO5
6 DIO6
7 DIO7
8 DIO8
9 DIO9
10 DIO10
11 DIO11
12 DIO12
Parameter range
0 - 0xFFFF (bit field)
Default
0
To Next Page
Loading...
Need help?
General
