Legacy S3B hardware certifications ISED (Innovation, Science and Economic Development Canada)
XBee®-PRO 900HP/XSC RF Modules
261
ISED (Innovation, Science and Economic Development Canada)
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Labeling requirements
Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on
the outside of the final product enclosure must display the following text.
Contains IC: 1846A-XB900HP
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B-
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts
FCC test report or CISPR 22 test report for compliance with ICES-003.
Contains IC: 1846A-XBEEXSC or Contains IC: 1846A-XBPS3B
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B-
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts
FCC test report or CISPR 22 test report for compliance with ICES-003.
To Next Page
Loading...
Need help?
General
