AT commands Addressing discovery/configuration commands
XBee®-PRO 900HP/XSC RF Modules
88
Default
0x0
CI (Cluster ID)
The application layer cluster ID value. The device uses this value as the cluster ID for all data
transmissions.
Parameter range
0 - 0xFFFF
Default
0x11 (Transparent data cluster ID)
DE (Destination Endpoint)
Sets or displays the application layer destination ID value. The value is used as the destination
endpoint for all data transmissions. The default value (0xE8) is the Digi data endpoint.
Parameter range
0 - 0xFF
Default
0xE8
SE (Source Endpoint)
Sets or displays the application layer source endpoint value. The value is used as the source endpoint
for all data transmissions. The default value (0xE8) is the Digi data endpoint.
This command only affects outgoing transmissions in transparent mode (AP = 0).
0xE8 is the Digi data endpoint used for outgoing data transmissions.
0xE6 is the Digi device object endpoint used for configuration and commands.
Parameter range
0 - 0xFF
Default
0xE8
Addressing discovery/configuration commands
AG (Aggregator Support)
The AG command sends a broadcast through the network that has the following effects on nodes that
receive the broadcast:
n The receiving node establishes a DigiMesh route back to the originating node, if there is space
in the routing table.
To Next Page
Loading...
Need help?
General
