Agency certifications - United States
United States (FCC)
The XBee-PRO XSC RF Modules comply with Part 15 of the FCC rules and regulations. Compliance with
the labeling requirements, FCC notices and antenna usage guidelines is required.
To fulfill FCC certification requirements, the OEMmust comply with the following regulations:
n The system integrator must ensure that the text on the external label provided with this
device is placed on the outside of the final product.
n XBee/XBee-PRO RF modules may only be used with antennas that have been tested and
approved for use with this module; refer to FCC-approved antennas (2.4 GHz).
OEM labeling requirements
WARNING! As an Original Equipment Manufacturer (OEM) you must ensure that FCC
labeling requirements are met. You must include a clearly visible label on the outside of the
final product enclosure that displays the following content:
XBee PRO S3
Note The S3 hardware variant is a legacy design that is obsolete. New and old designs should use the
S3B hardware variant.
Required FCC Label for OEM products containing the XBee-PRO XSC RF Module:
Contains FCC ID: MCQ-XBEEXSC
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (i.) this device may not cause harmful interference and (ii. ) this device
must accept any interference received, including interference that may cause undesired
operation.
Or
XBee PRO S3B
Contains FCC ID: MCQ-XBPS3B
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (i. ) this device may not cause harmful interference and (ii. ) this
device must accept any interference received, including interference that may cause undesired
operation.
XBee®-PRO 900HP/XSC RF Modules
258
To Next Page
Loading...
Need help?
General
