Revision history—90002173
Revision Date Description
S October
2016
Replaced the Programmable bootloader section with the Programmable XBee
SDK section. Updated the indoor range spec. Corrected the SPand ST
parameter default values.
T May
2018
Added note on range estimation. Changed ICto ISED.
U July
2018
Added the 0x00, 0x80 and 0x89 frames for the 900HP.
V June
2019
Added FCC publication 996369 related information.
W January
2020
Added IFETEL certifications.
Trademarks and copyright
Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United
States and other countries worldwide. All other trademarks mentioned in this document are the
property of their respective owners.
© 2020 Digi International Inc. All rights reserved.
Disclaimers
Information in this document is subject to change without notice and does not represent a
commitment on the part of Digi International. Digi provides this document “as is,” without warranty of
any kind, expressed or implied, including, but not limited to, the implied warranties of fitness or
merchantability for a particular purpose. Digi may make improvements and/or changes in this manual
or in the product(s) and/or the program(s) described in this manual at any time.
Warranty
To view product warranty information, go to the following website:
www.digi.com/howtobuy/terms
Customer support
Gather support information: Before contacting Digi technical support for help, gather the following
information:
Product name and model
Product serial number (s)
Firmware version
Operating system/browser (if applicable)
XBee®-PRO 900HP/XSC RF Modules
2
To Next Page
Loading...
Need help?
General
