XBee®-PRO 900HP/XSC RF Modules
6
Indirect messaging 55
Polling 56
Sleeping routers 56
Sleep coordinator sleep modes in the DigiMesh network 56
Synchronization messages 57
Become a sleep coordinator 59
Select sleep parameters 61
Start a sleeping synchronous network 61
Add a new node to an existing network 62
Change sleep parameters 63
Rejoin nodes that lose sync 63
Diagnostics 64
Query sleep cycle 64
Sleep status 64
Missed sync messages command 65
Sleep status API messages 65
Networking methods
The MAC and PHY layers 67
64-bit addresses 67
Make a unicast transmission 68
Make a broadcast transmission 68
Delivery methods 68
Point to Point / Point to Multipoint (P2MP) 68
Repeater/directed broadcast 69
DigiMesh networking 70
AT commands
Special commands 76
AC (Apply Changes) 76
FR (Force Reset) 76
RE (Restore Defaults) 76
WR (Write) 76
MAC/PHY commands 77
AF (Available Frequencies) 77
CM (Channel Mask) 77
MF (Minimum Frequency Count) 78
HP (Preamble ID) 78
ID (Network ID) 79
MT(Broadcast Multi-Transmits) 79
PL (TX Power Level) 79
RR (Unicast Mac Retries) 80
ED (Energy Detect) 80
Diagnostic commands 80
BC (Bytes Transmitted) 80
DB (Last Packet RSSI) 80
ER (Received Error Count) 81
GD (Good Packets Received) 81
EA (MAC ACK Failure Count) 81
TR (Transmission Failure Count) 82
UA (MAC Unicast Transmission Count) 82
%H (MAC Unicast One Hop Time) 82
To Next Page
Loading...
Need help?
General
