82
160XT 180XT 210XT
FAULT REMEDY
7. Boom drifts slowly downward
The “lock valve”, i.e. the pressure activated
check valve, is leaking.
Remove and clean the valve.
Check the condition of the o-rings.
Install the valve carefully – the correct
tightening torque is 60 Nm.
If necessary, replace the valve.
8. Power unit does not start
Battery is flat. Recharge the battery.
The mains cable is plugged. Disconnect the plug from the mains.
No direct-current supply (12VDC). Main switch has been turned off, turn on the
switch.
9. Power unit cranks but does not start
Fuel tank is empty. Fill the fuel tank.
Choke is off. Press the choke button (cold engine).
Throttle lever in idling position. Increase the engine revolutions.
10. Boom cannot be lifted
Refer to item 4.
Electric valve is open.
Remedy as instructed above in conjunction
with the seizure of the electric valve spool.
The lift turns when the lifting movement is
activated.
Solenoid valve is stuck in the turning
position.
Wash carefully the spool and the housing.
Courtesy of Crane.Market
To Next Page
Loading...
