Dish Network 500 - Reset the Receiver

Chapter 3
Page 76
Using the System
Up/Down Arrow Buttons
Use these buttons to change channels on the cable box.
Select Button
The SELECT button works as the ENTER button for the cable
box.
Recall Button
Press this button to go back to the last cable box channel you used.
Press it again to switch between the last two cable box channels
you used.
Number Buttons
Use these buttons to enter channel numbers.
Control a Tuner or Amplifier
Only the buttons we tell you about here control a tuner or amplifier.
Some of the buttons we tell you about here may not control your
tuner or amplifier. Please see the user’s manual that came with your
tuner or amplifier for more information.
Aux Mode Button
You must first set up the remote to control the device. Please see Set
Up the Remote to Control Devices, beginning on page 68. Then, you
must press the AUX mode button to set the remote to AUX mode. The AUX
mode button flashes once to show you’ve set the remote to AUX mode. Make
sure you keep the remote in AUX mode to use the buttons we tell you about
here.
Power Button
Press the blank POWER button to turn the tuner or amplifier on
or off.
Tip: Some of
the buttons
we tell you
about here
may not
control your
tuner or
amplifier. Be
sure to check
the user guide
that came
with the
device for full
details.