101ECLYPSE Connected Thermostat (ECY-STAT)
CHAPTER 11
Rebooting or Resetting the Controller
This chapter describes how to recover control over the controller by rebooting it or resetting it to the
factory default settings.
Rebooting the Controller
See
Mounting Instructions
in the ECLYPSE Connected Thermostat (ECY-STAT) Installation Guide for
the front cover removal procedure.
1. Separate the front cover from the back plate.
2. Replace the front cover on the back plate.
Resetting the Controller to its Factory Settings
Performing a factory reset will return the device to its factory default settings. User accounts (user
names and passwords) will also be reset to the factory default settings and the controller’s license and
HTTPS security certificates will be cleared.
Always backup the controller's license through the controller's Web interface before performing a factory reset. Once
the controller reboots, you will have to reinstall the license through the controller's Web interface.
To backup and install the license, see System Settings. Click
Export To PC
to backup the controller's license to your
PC. Click
Import From PC
to restore the controller's license file from your PC.
After you use the factory reset switch, the controller’s HTTPS security certificates will be regenerated. If you use
HTTPS to connect to the controller, you will no longer be able to connect to the controller from any PC that was used
in the past to connect to the controller unless you delete the old HTTPS security certificate from these PCs. See
Removing a Certificate.
Once the factory reset procedure is started, it cannot be cancelled.
Factory Reset Switch Location
Rebooting or Resetting the Controller