PROTECTION FROM FALLING OR FLYING OBJECTS
On work sites where there is danger that falling
objects or flying objects may hit the operator's cab
select a guard to match the operating conditions to
protect the operator.
Work in mines, tunnels, deep pits or on loose or wet
surfaces could produce danger of falling rock, roll
over or hazardous flying objects. Additional
protection for operator‘s cab could be required in
form of a FOPS/Falling Object Protective Structure
and/or ROPS/Roll Over Protective Structure
reinforcement system (Option).
Any reinforcement system that is installed on
machine must pass safety and certification
standards and carry appropriate labeling and rating
information. For example, most often added type of
reinforcement system, FOPS, must meet or exceed
Society of Automotive Engineers standard SAE
J1356, "Performance Criteria for Falling Object
Guards for Wheel loaders. (Option)"
Never attempt to alter or modify any type of protective structure reinforcement system, by drilling holes,
welding or remounting or relocating fasteners. Any serious impact or damage to system requires a complete
integrity reevaluation. Reinstallation, recertification and/ or replacement of system may be necessary.
INSTALL ADDITIONAL SAFETY EQUIPMENT IF CONDITIONS REQUIRE
Laminate glass protection for the front, side or rear windows may also be recommended depending upon
particular site conditions.
Contact your DISD distributor for available safety guards and/or recommendations if there is any danger of
getting hit by objects that could strike the operator‘s cab. Make sure that all other work site crew members
are kept well away from wheel loader and safe from potential hazards.
MAINTAIN STANDARD SAFETY EQUIPMENT IN GOOD CONDITION
Machinery guards and body panel covers must be in place at all times. Keep well clear of rotating parts.
Pinch point hazards such as cooling fan and alternator drive belts could catch hair, jewelry or oversize or
very loose clothing.
Safety labels must be replaced if they are damaged or become unreadable. Information on labels gives work
crew members an important safety reminder. Part numbers for each decal and required mounting locations
are shown on pages 1-2 through 1-4 of this section.
S0103010K Wheel Loader Safety
Page 12
To Next Page
Loading...
