BATTERY HAZARD PREVENTION
Battery electrolyte contains diluted sulfuric acid and batteries generate hydrogen gas. Hydrogen gas is highly
explosive, and mistakes in handling them can cause serious injury or fire. To prevent problems, always do
the following;
• Do not smoke or bring any flame near the battery.
• When working with batteries, ALWAYS wear safety glasses and rubber gloves.
• If you spill battery electrolyte on yourself or your clothes, immediately flush the area with water.
• If battery electrolyte gets into your eyes, flush them immediately with large quantities of water and see a
doctor at once.
• If you accidentally drink battery electrolyte, drink a large quantity of water or milk, raw egg or vegetable oil.
Call a doctor or poison prevention center immediately.
• When cleaning the top surface of the battery, wipe it with a clean, damp cloth. Never use gasoline,
thinner, or any other organic solvent or detergent.
• Tighten the battery caps securely.
• Explosive battery gas can be set off by sparks from incidental contact or static discharge. Turn "OFF" all
switches and engine when working on batteries. Keep battery terminals tight. Contact between a loose
terminal and post can create an explosive spark.
• If the battery electrolyte is frozen, do not charge the battery or start the engine with power from another
source. There is danger that the battery may catch fire.
• When charging the battery or starting with power from another source, let the battery electrolyte melt and
check that there is no leakage of battery electrolyte before starting the operation.
• Always remove the battery from the machine before charging.
DISCONNECT BATTERIES BEFORE ELECTRICAL SERVICE OR ELECTRICAL WELDING
Remove cable to negative terminal first when disconnecting cable. Connect positive terminal cables first
when installing a battery.
S0103010K Wheel Loader Safety
Page 32
To Next Page
Loading...
