Windshield Wiper
Windshield wiper can be operated by combination switch (2).
1. Low speed wiper (I gear)
When wiper is running with low speed, electric current comes from fuse box (1), goes through wire
inlet terminal and terminal ―L‖ of wiper motor (3), reaches terminal ―6‖ and ―4‖ of combination switch
(2) and connects with earth.
2. High speed wiper (II gear)
When wiper is running with high speed, electric current comes from fuse box (1), goes through wire
inlet terminal and terminal ―H‖ of wiper motor (3), reaches terminal ―1‖ and ―4‖ of combination switch
(2) and connects with earth.
Through the rocket switch (7) control rear window wiper blade and scrubber
1 .Single windshield wipers gear (not automatic reset)
When Wiper blade in the running gear, the current from the fuse box (1) through the windscreen wiper
motor (5) into line terminal to rocket switch (7) terminal "4", "2", then grounding.
2. The windshield wipers and scrubber combination gear (can be automatically reset).
When Wiper blade in the running gear, the current from the fuse box (1) through the windscreen wiper
motor (5) and washing machine (6) into line terminal to rocket switch (7) terminal "1", "7",then
grounding.
Electrical System SPC000025
Page 21
To Next Page
Loading...
