Doosan DISD SD 310 - Page 395

Tilt gear case 90.
Remove lock plate.
Loosen hex. head screws and pull off output flange.
NOTE ;
If only operations on the transmission are necessary,
the complete retarder can be separated from the
converter compartment by loosening the screwed
connection (Figure 8)!
Loosen screw plug.
Loosen first hex. head screw and remove it by
means of magnetic rod.
Remove the remaining hex. head screws
accordingly.
Loosen screwed connection.
Transmission and Torque Converter SPC000007
Page 167
Figure 5
Figure 6
Figure 7
Figure 8