Doosan DISD SD 310 - Page 85

I. "Loctite" Fastener Adhesives
Product
Application
Color
Removal
Break-away
Cure Strength
(in lb) of Sealer
Alone
222
Low strength for 6 mm (1/4") or smaller
fasteners.
Purple
Hand tools
45
242 or
243
Medium strength for 6 mm (1/4") and
larger fasteners.
Blue
Hand tools
80
262
High strength for high grade fasteners
subject to shock, stress and vibration.
Red
Heat/260°C (500°F)
Remove HOT
(NO solvent)
160
271
Extra high strength for fine thread
fasteners up to 25 mm (1") diameter.
Red
Heat/260°C (500°F)
Remove HOT
160
272
High temperature/high strength for
hostile environments to 232°C (450°F).
Red
Heat/316°C (600°F)
Remove HOT
180
277
Extra high strength for coarse thread
fasteners 25 mm (1") diameter and
larger.
Red
Heat/260°C (500°F)
Remove HOT
210
II. "Loctite" Pipe Thread Sealant
Product
Application
Color
Removal
Required Setup
545
"No-filler/non-clog" formula for high-pressure
hydraulic systems. Over-application will not
restrict or foul system components.
Purple
Hand
tools
4 Hours (or 1/2 hour
with Locquic "T"
Primer)
656
Solvent-resistant, higher viscosity tapered
thread sealer.
White
Hand
tools
4 Hours (or 1/2 hour
with Locquic "T"
Primer)
III. "Loctite" gasket/flange sealer
Product
Application
Color
Notes
518
Gasket eliminator specifically made for
aluminum flanges/surfaces. For hydraulic
systems to 34,475 kPa (5,000 psi).
Red
Use Locquic "N" primer for fast (1/2
- 4 hours) setup. Unprimed setup 4 -
24 hours.
504
Low pressure/wide-gap gasket eliminator
compound. Fills gaps to 0.0012 mm (0.030"),
cures to rigid seal.
Orange
Use Locquic "N" primer for faster
(1/2 - 4 hours) setup. Unprimed
setup 4 - 24 hours.
515
General purpose, fast setup, flexible-cure
gasket eliminator. For nonrigid assemblies
subject to shock, vibration or deflection.
Purple
Use Locquic "N" primer for faster
(1/4 - 2 hours) setup.
Unprimed setup 1 - 12 hours.
Standard Torque S0309000
Page 11