Dover HEIL Command-SST - Lifting and Loading Refuse (Continued)

Issued June 2020
Operation
Copyright 2020, Heil Environmental
Printed in U.S.A.
90
LIFTING AND LOADING REFUSE
(CONTINUED)
DANGER
Contact of the unit with overhead electric lines is
dangerous. Serious injury or death may occur. Make sure
there is adequate overhead clearance before you raise the
container. Refer to Tables 1 and 2. Overhead
Clearances . If the unit does make contact with
overhead electric lines do not touch any metal in the cab.
Stay in the unit until help arrives.
NOTICE
If local rules and laws require more clearance, you must
follow them.
NOTICE
Make sure the container is in the center of the grabbers.
DO NOT use the tips of the grabbers to squeeze and lift
the container.
8. MOVE the joystick to the OUT position and HOLD
until the arm is in position to pick up the refuse
container.
9. DEPRESS and HOLD the right black button on the
joystick, the grabbers CLOSE around the can, and
the arm automatically carries the can up and into the
hopper, dumping automatically.
Note: All units are equipped with the Auto-Lift feature.
When operating in Normal Mode, Weigh Mode or
Spear Mode, this feature is enabled automatically
and allows the operator to partially automate the
lifting, dumping and returning of the refuse container
to the ground.
For units equipped with the Heil Autonomous Lift
Option (H.A.L.O.), press the red button to grab, dump
and return a cart to its original location. See
Features and H.A.L.O. Joystick Controls .
You would then be able to skip Steps 10-13 below.
NOTICE
When the arm is in the UP, IN and DUMP position,
DEPRESS and HOLD button to perform a can shake. This
feature will only be active while the button is depressed,
with three (3) shakes per button press.
10.When the container is empty of refuse, PUSH and
HOLD the joystick to the UNDUMP position. The lift
arm will rotate the container out of the hopper and
lower the container to the ground.
11.DEPRESS and HOLD the left black button on the
joystick, the grabbers RELEASE the container and
move the lift arm IN to the work position.
13.Press the STOW POS button on the Supporting
Functions Push Button Controls to return lift to
stowed position.
14.Go to the next stop on the route.
28
65 76
72