Printed in U.S.A.
PRESSURE ADJUSTMENT SETTINGS
A.Unit Preparation
Follow these unit preparation steps prior to making any pressure adjustments listed in this section.
1. Make sure area around unit is clear.
2. Place wheel chocks on both sides of driver side rear wheel.
3. Make sure parking brake is set.
4. Notify anyone in area that the unit will be operated during this procedure.
5. Make sure unit is full of hydraulic oil.
6. Make sure hydraulic oil is at least 120 degrees F before beginning any pressure checks or adjustments. See Cold
Weather Warmup Procedure .
The unit must remain in neutral during all pressure setting procedures. Make sure that the work area is clear of uninvolved
people and that the parking brake is fully applied and wheels fully chocked.
To Next Page
Loading...