Printed in U.S.A.
LEAVING THE ROUTE FOR THE LANDFILL/
TRANSFER STATION
At the end of the route, or when the unit has a full load,
prepare the unit to go to the landfill.
The Body is fully LOWERED.
The Tailgate is DOWN and LOCKED.
The Lift Arm is in a transit position:
o The lift arm is fully stowed in the cradle
o The grabber arm assembly is against the chassis
and the grabbers are fully open
The Top Door (Hopper Cover) is:
o For a unit before it is on-route – CLOSED
o For an on-route unit – OPEN
The Packer Panel is:
o For an empty unit, it is at the front of hopper.
o For a unit with refuse in the body, it is up tight
against refuse.
The PTO or Pump Switch is OFF.
The Mirrors are properly adjusted and clean.
The Side Access Door and Sump Doors are
CLOSED and LATCHED.
ALL outside lights operate properly.
The street side driver's station is used for traveling.
Use of Curb Side Drive
If equipped, drive from the curbside driver position ONLY
on the collection route. DO NOT use this station during
travel to and from a route, landfill, or transfer station.