Issued June 2020
Operation
Copyright 2020, Heil Environmental
Printed in U.S.A.
64
FEATURES
Display for displaying the current status of inputs/outputs,
engine speed, temperatures, etc. This can also be used for
configuring or selecting different options in the Cortex
Controller and placing the unit in various Operation Modes
.
For more information, see InSight Diagnostic Display .
Auto-Lift
Auto-Lift Mode is standard on all Cortex Controller
controlled units. While in Normal Mode, the lift will
automatically raise and dump with lift raise function. See
Operation Modes .
Select-O-Pack is a standard feature on all Cortex
Loaders. This feature automatically cycles the Auto-Pack
after a predetermined number of lift cycles. This setting can
be adjusted on the InSight Diagnostic Display.
Refer to Select-O-Pack Adjust Screen and Operation
Specifications for more information.
You can also pack the refuse manually any time after
loading the refuse in the hopper. You can use the in-cab
controls for the packer panel to compact the load again
with a manual cycle.
Auto/Manual Pack Mode
Auto/Manual Pack Mode is a standard feature on all Cortex
packer will complete its cycle automatically with a
momentary activation of the packer extend push button.
While in manual mode, it will be necessary to hold the
packer extend or retract buttons in order to keep the packer
cycling.
Also while in manual mode, all control interlocks will be
disabled. This is only intended for special occasions when
an operator needs to bypass the control interlocks.
To toggle the control between Auto and Manual Pack
Modes with the System Power (E-Stop) button ON, PRESS
and HOLD the Packer Extend and Retract buttons
simultaneously until the in cab alarm stops sounding.
Operation Modes
There are several Operation Modes available to Operators.
Some modes should only be used by Authorized Service
Personnel, such as Service and Calibration Modes. See
Operation Modes for more information.
68
99
68
103
66
68
To Next Page
Loading...